Step 4; See Figure 4:
Install right & left Front Posts (5) and right & left Top Frame Braces (6 & 7).
Note: Bent ends of Top Frame Braces will point rearwards and lay flat when properly installed.
A. Insert a 1/4” x 3/4” bolt forward through the tab on the post, the end of the Front Panel Frame and then the lower end of the Top Frame Brace. Add a nut. Tighten just enough to hold the braces up.
B.Insert a 1/4” x 3/4” bolt outwards through the lower hole in the foot, the lower hole in the post and then the right Foot Pocket Guard (shorter than left). Add a nut. Tighten enough to hold the Foot Pocket guard as shown.
C.Insert a bolt out through the upper hole in the Foot and Post. Place a door hinge from the Door Hardware Package over the bolt and add a nut. Do not tighten at this time.
D.Repeat on left side of tractor.
Step 5; See Figure 5:
Install Rear Cross Bar Brackets (8) and Rear Cross Bar (9)
A.Remove the bolts at Reference B.
B.Place the Rear Cross Bar Brackets over the holes as shown. Replace the bolts. Do not tighten at this time.
C.Place the tabs welded to the Rear Cross Bar over the brackets as shown. Insert two bolts down through the holes and add locknuts. Do not tighten at this time.
5 |
|
|
| 7 |
6
Figure 4
B
8
9
Figure 5
7
