Step 8: See Figure 8:
Install the Doors for frame / door alignment.
A.Follow the instructions in the Door Hardware Package to install the Door Bottoms and the Door Latches.
B.Install, close and latch both Doors.
C.Tighten all bolts from previous steps at this time. Add two 5/16” nuts to the Front Panel Frame leg bolts at reference A. Tighten securely.
Note: If door latch rod does not line up with notch in latch plate loosen the Foot clamp and move Foot forward or rearward to raise or lower the rod. Tighten the clamp.
D.Remove the Doors to complete the installation.
Step 9: See Figure 9:
Install Windshield (17) and Front Panel Vinyl (16).
A.Place the Windshield and Front Panel Vinyl face up on a clean flat surface. Press the hook and loop fastener together.
B.Lay the rod sewn into the top of the windshield over the top frame. Close the snap flaps around the corners of the top frame.
C.Secure the ties to the cross bar and close the snap flaps around the posts.
D.Lock the brake pedal down. Fit the vinyl around the Foot Pocket Guards and Pedals. Connect the hook and loop fastener under the step plates .
Figure 8
17
Figure 9
A
16
9
