Snapper 1695419, 1694151 manual Install the Lift Rod, Initial Setup & Installation

Initial Setup & Installation

	A
& Installation	D
	B
Setup
	C

Figure 11. Lift Linkage Installation

A.Turn Crank

B.Clevis Pin and Safety Clip

C.Lift Rod

D.Front Bracket

Install the Lift Rod

1.Connect the rear of the lift rod (C, Figure 11) to the upper hitch. Secure with a clevis pin (B) and safety clip.

2.Slide the lift bracket (A, Figure 12) and lift rod assembly on the right stub at the end of the lift assembly cross-shaft. Secure with a clevis pin and hair pin clip (see Figure 12 inset).

MANUAL LIFT MODELS ONLY:

A

Figure 12. Lift Arm Extension Installation A. Lift Bracket

3.Mount the front bracket (D, Figure 11) to the frame using a 5/16-18 x 1 capscrew and nylock nut.

4.Secure the rear turn crank assembly (A, Figure 11) to the rear hitch using 3/8-16 x 1 carriage bolt and nylock nut.

5.Hook the spring to the turn crank (A) and put the threaded rod through the front bracket (D). Turn the crank until the nut is captured in the front bracket.

12