Snapper 1695464 manual Turbo Installation, Install Front Baffles, Install Hook Plate

Turbo Installation

Install Front Baffles

1.Remove and discard existing baffle from the left side of the mower deck. It is replaced by turbo baffles.

2.Install the left (23-1/2” long) baffle and right (26-1/2” front baffle (A and B, Figure 1) using six carriage bolts (C), lockwashers (D), and nuts (E). Be sure the bolts are inserted fully into the slots in the mower deck.

E	E
D	D
B
C
A	C

Figure 1. Install Front Baffles

A.Left Front Baffle (23-1/2” Long)

B.Right Front Baffle (26-1/2” Long)

C.5/16-18 x 3/4 Carriage Bolts

D.Lockwashers

E.5/16-18 Nuts

Install Hook Plate

WARNING

Before beginning any service work turn off the PTO, set the parking brake, turn off the ignition, and disconnect the spark plug wire(s).

1.Remove the deflector, spring, and hinge assembly. Use a hammer to drive the carriage bolts back through the deck, and discard the deflector.

2.Install the hook plate (A, Figure 2) below the stone guard (located at the bottom of the discharge open- ing) using two carriage bolts (B) and flange locknuts

(C). Install bolts from the bottom up.

3.Install retainer nut (D) on hook plate.

C
Stone	C
	Stone
Guard
	Guard
D	B
	A

Figure 2. Install Hook Plate

A.Hook Plate

B.5/16-18 x 3/4 Carriage Bolts

C.Flange Locknuts

D.Retainer Nut

6