Figure 10. Bar Stop
A.Bar Stop
B.Taptite Screw,
INITIAL SETUP & ASSEMBLY
NOTE: Some of the following setup procedures may already be completed.
Assemble Blade
1.Place the blade on a flat surface.
2.See Figure 10. Install one bar stop (A) using the two
3.See Figure 11. Insert threaded end of eyebolt (A) through lug on blade, and screw on 5/16 nut (B) just far enough so that it is flush with the end of the eye- bolt.
4.See Figure 11. Hook the springs (C) into the pivot frame (D). Using a pliers, stretch the springs to hook the opposite ends to the eyebolts (A).
5.See Figure 11. Tighten the nut (B) on each eyebolt enough to expose about 3/4" (19 mm) of thread.
6.See Figure 11. Holding the first nut (B) with a wrench,add a second nut (E) to each eyebolt, and tighten securely against the first nut to act as a jam nut.
Assemble & Install Hitch
1.See Figure 12. Assemble the
(A) to the hitch assembly (E). Secure with capscrew, lockwasher, and nut.
Initial Setup & Assembly
Figure 11. Tension Springs |
|
A. Eyebolt | D. Pivot Frame |
B. Nut, 5/16 | E. Nut, 5/16 |
C. Spring |
|
| E |
| A |
B | D |
| |
| C |
Figure 12. Spring Assist Bracket
A.Spring Assist Bracket
B.Capscrew,
C.Lockwasher, 1/2
D.Hex Nut,
E.Hitch
11