A | B |
|
Figure 21. Underside of Left Footrest.
A.Carriage Bolt, Lockwasher, & Nut
B.Pedal Plate
Initial Setup & Assembly
A | B |
| |
C |
|
Figure 22. Control Rod Support
A.Support
B.
C.5/16 Lockwashers & Nuts
Install Angling Control Rod
NOTE: If installing the dozer attachment on a unit equipped with a snowcab, replace the control rod sup- port (A, Figure 22) with the hanging support (Ref. No. 41, Figure 8). Mount the hanging support to the front cab
1.Remove and discard the two rear nuts, lockwashers, and carriage bolts (A, Figure 21) securing the back of the foot pedal plate (B).
2.Using the foot pedal plate (B) as a guide, drill two 5/16” holes up through the foot pedal pad.
3.Set the angling control support (A, Figure 22) on the foot rest pad. Insert two
4.Connect the lower angling rod (F, Figure 23) to the dozer release lever using a hair pin clip and washer
(G).
5.Insert the upper control rod (C) through the eyelet (B), and secure the eyelet to the support using a 1/4- 20 nylock nut (A).
NOTE: It may be necessary to leave the eyelet nut (A, Figure 23) loose to prevent binding.
6Secure the upper rod (C) to the lower rod (F) using two
D | C |
| B |
|
|
| |
|
| E | A |
|
|
| |
F |
|
|
|
| G |
|
|
Figure 23. Assemble Control Rods
A.
B.Eyelet
C.Upper Control Rod
D.
E.5/16 Washers, Lockwashers, & Nuts
F.Lower Control Rod
G.Hair Pin Clip & Washer
15