Snapper 285Z Operation, General Operating Safety, Checks Before Starting, grass catcher, spills

Operation

General Operating Safety

Before first time operation:

•Be sure to read all information in the Safety and Operation sections before attempting to operate this rider and mower.

•Become familiar with all of the controls and how to stop the unit.

•Drive in an open area without mowing to become accus- tomed to driving the unit.

Checks Before Starting

•Check that the crankcase is filled to full mark on dipstick (A, Figure 1 - located under engine cover). See the engine owner’s manual for instructions and oil recommendations.

•Make sure all nuts, bolts, screws and pins are in place and secure.

•Adjust the seat position (B), and make certain you can reach all controls from the operator’s position.

•Fill the fuel tank (C) with fresh fuel. Refer to the engine owner’s manual for fuel recommendations.

WARNING
Never operate on slopes greater than 18 percent (10°).			B
Select slow ground speed before driving onto a slope. Use
extra caution when operating on slopes with a rear-mounted
grass catcher.	Reproductrider. This rideriohas na zero turning radius and the rear
spills.
Mow up and down slopes, not across the face, use caution
when changing directions and DO NOT START OR STOP ON
SLOPE.			C
			A
WARNING
Never allow passengers to ride on the unit.
Before leaving the operator’s position for any reas		n, l ck
the ground speed levers in the START/PARK position,
engage the parking brake, disengage the PTO, stop the
engine and remove the key.
To reduce fire hazard, keep the engine, rider and mower f ee			Figure 1. Pre-Start Checks
of grass, leaves and excess grease. Do not stop or		ark rider
over dry leaves, grass or combustible materials.			WARNING
Gasoline is highly flammable and must be handl		with
care. Never fill the tank when the engine is still hot from			Do not load this zero-turn rider on a trailer or truck using
recent operation. Do not allow open flame, smoking or
			two separate ramps. Only use a single ramp that is at least
matches in the area. Avoid over-filling and wipe up any
			one foot wider than the width of the rear wheels of this
			wheels could fall off the ramps, or the rider could tip over
WARNING			injuring the operator or bystanders.

If you do not understand how a specific control functions, or have not yet thoroughly read the FEATURES & CONTROLS section, do so now.

Do NOT attempt to operate the rider without first becoming familiar with the location and function of ALL controls.

14 www.Snapper.com