Adjustments and Service
A |
A |
B |
B |
Figure 14. Ground Speed Lever Adjustments
|
|
| Speed Balancing Adjustment | ||||
|
|
| If the rider drifts to the right or left when the ground speed | ||||
Figure 13. Seat Adjustment |
| ||||||
|
| levers are in the maximum forward position, the top speed of | |||||
|
|
| each of these levers can be bala ced. Only adjust the speed of | ||||
Seat Adjustments |
|
| the wheel that is traveli g faster. | ||||
|
| To Reduce the Speed f the Faster Wheel | |||||
The seat and ground speed levers should be adjusted so that |
| ||||||
1. | L sen the b lt secur ng the forward adjust plate (B, | ||||||
operator’s elbows are supported by the arm rests when his/her | |||||||
|
|
| Figure 14). | ||||
hands are on the controls, and the ground speed levers can be |
|
|
| ||||
2. | Slide the plate up approximately 1/8”. | ||||||
moved through their full range of motion without c n ac ing | |||||||
the operator’s legs. |
| 3. | Retighten the bolt and recheck speed balance. | ||||
Seat Position Adjustment |
| 4. | Repeat steps | ||||
Lift the seat adjustment lever (A, Figure 13). Slide the seat |
|
|
|
|
| ||
forward or backward to the desired position, then lower the |
|
|
| WARNING |
| ||
seat adjustment lever. Make sure the lever locks into the |
|
|
|
|
| ||
locking slots (B) in the seat base. |
|
|
| DO NOT adjust the rider for a faster overall speed forward or | |||
|
|
|
| ||||
Ground Speed Lever Adjustment |
|
|
| reverse than it was designed for. | |||
|
|
|
|
|
| ||
To Adjust the Handle Height: Remove the ground sp | l v |
|
|
|
|
| |
mounting hardware (A, Figure 14) and reposition the lever |
|
|
|
|
| ||
either up or down from its original position. eplace the |
|
|
|
|
|
|
hardware.Reproduction
22 | www.Snapper.com |