Adjustments and Service
Installation
1.Disengage the PTO, engage the parking brake, lock the ground speed levers into their START/PARK positions, turn off the ignition, remove the key, and wait for all moving parts to stop.
2.Lower the mower deck to its lowest position. See
“CUTTING HEIGHT ADJUSTMENT”.
3.Pivot the front wheels out of the way and slide the mower deck under the unit. Place a 2 x 4 or similar support under each end of the mower deck.
A |
C |
B |
4. Insert the front lift rods (C, Figure 18) into the bottom |
| Figure 17. Rear Deck Lift Components |
| ||
| (Right side shown, left side same) |
|
| ||
holes in the front mower deck bracket (B), and secure each |
|
|
| ||
|
|
|
| ||
with a washer and hairpin clip (A). |
|
|
|
|
|
5. Insert the rear lift arms (C, Figure 17) into the front holes |
|
|
|
| |
in the rear mower deck brackets (B), and secure each with |
|
|
|
| |
a washer and hairpin clip (A). |
|
|
|
|
|
6. Pull back on the tensioning idler (D, Figure 16) in the direc- |
|
|
| ||
| Reproduction |
|
| ||
tion indicated, and install the belt onto the PTO pulley as | for |
|
| ||
shown in Figure 16. |
|
|
|
|
|
Important: Be sure the belt is installed properly onto all pulleys. |
|
|
| ||
| Not |
| C | A | B |
|
|
| |||
Figure 18. Front Deck Lift Components
Right side shown, left side same)
24 | www.Snapper.com |
