Snapper 355Z manual Seat & Safety Switch Assembly, Seat Adjustment, Seat Position Adjustment

Seat & Safety Switch Assembly

1.Pivot the ground speed / steering control levers out to the NEUTRAL position and pivot the seat plate (B, Figure 5) forward.

2.Mount the seat (A) to the seat plate (B) using four 5/16- 18 nylock flange nuts (C) and tighten securely.

3.Press the seat switch wire harness end (D) onto the seat switch until the latch of the seat switch wire harness end snaps down over the lock on the seat switch.

Seat Adjustment

The seat and ground speed control levers should be adjusted so that operator’s elbows are supported by the arm rests when his/her hands are on the controls, and the ground speed control levers can be moved through their full range of motion without contacting the operator’s legs.

Seat Position Adjustment

The seat can be adjusted forward and back. Move the adjustment lever (A, Figure 6) towards the left hand side of the machine, slide the seat to the desired position, and release the lever.

B

A

C

D

C

Figure 5. Seat Installation

A.Seat

B.Seat Plate

C.5/16-18 Nylock Flange Nut (4)

D.Seat Switch Wire Harness

A

Figure 6. Seat Adjustment

A. Adjustment Lever

13