Snapper 522E Assembling the Snowthrower, Tools Required, Removal From Carton, Assembly Procedure

Assembling

the Snowthrower

TOOLS REQUIRED

• Knife

REMOVAL FROM CARTON

1.Locate and remove container of oil.

2.Locate all parts packed separately and remove from carton.

Note: Set the fuel stabilizer aside until adding gasoline to the fuel tank. We recommend that fuel stabilizer be added to the fuel each time that gasoline is added to the fuel tank.

3.Remove and discard the packing material from around the snow thrower.

4.Cut down all four corners of the carton and lay the panels flat.

5.Hold onto the lower handle and pull the snow thrower off the carton.

CAUTION: DO NOT back over cables.

6.Remove the packing material from the handle assem- bly.

ASSEMBLY PROCEDURE

Snowthrower

If your unit was not previously assembled, see Figure 1 and follow the steps below to assemble the unit:

1.Lift up folding handle to align it with lower handle and tighten the t-knobs securely as shown in Figure 2.

	A
	E
	F
C	B
D
	C

Figure 1. Snowthrower (Shown Assembled)

A.Auger Drive Lever

B.Auger Drive Cable

C.T-Knobs

D.Chute Deflector

E.Crank Assembly

F.Recoil Starter

Figure 2. Lift Handles and T-Knobs

8