A
B
C
Figure 3. Z-Hook Installation
A.Auger Drive Lever
B.
C.Auger Drive Cable
2.Attach the auger drive cable (C, Figure 3) to the auger drive lever (A) using the
3.Remove the
4.Rotate the upper chute (A) to the operating position (past the lower chute stop)
5.Install the bolt and tighten the
Engine
1.The snow thrower was shipped with a container of 5W30engine oil. Before operating, add this oil to the engine.
2.Remove the oil fill cap/dipstick access panel (A, Figure 5).
3.Remove the oil fill cap/dipstick (B). Fill to the FULL mark on the oil fill cap/dipstick. Periodically check the oil level. DO NOT OVER FILL.
4.If not installed, install the fuel cap (C) onto the fuel tank.
Assembling the Snowthrower
A |
C |
B |
Figure 4. Upper Chute Installation
A.Upper Chute
B.
C.Lower Chute
A |
C |
B |
Figure 5. Add Engine Oil
A.Access Panel
B.Oil Fill Cap/Dipstick
C.Fuel Cap
9