Snapper 5900683, 5900709, 5900734 manual Regular Maintenance

Maintenance

Regular Maintenance

Mower Belt Replacement - 48” Deck Models

NOTICE

To avoid damaging belts, DO NOT PRY BELTS OVER PULLEYS.

1.Park the tractor on a smooth, level surface such as a concrete floor. Disengage the PTO, engage the parking brake, turn off the engine, and remove the ignition key.

2.Lower the mower deck to its lowest cutting position and remove the mower deck guards.

3.Using a 1/2” breaker bar, place the square end in the square hole located in the end of the idler arm (A, Figures 43). Carefully rotate the breaker bar CLOCKWISE, which will relieve the tension on the belt exerted from the idler arm.

WARNING

Use extreme caution when rotating the idler arm with the breaker bar, due to the increased tension in the spring as the idler arm is being rotated. Injury may result if the breaker bar is prematurely released while the spring is under tension.

4.Slide the drive belt over the edge of the stationary idler pulley (B). Carefully release the tension on the breaker bar.

5.Remove the old belt and replace with a new one. Make sure the V-side of the belt runs in the pulley grooves (Figure 44).

6.Install the drive belt on the PTO pulley, the spindle pulleys and all idler pulleys except the stationary pulley (B, Figure 43). Carefully rotate the breaker bar CLOCKWISE and install the belt on the stationary idler pulley (B). Carefully release the tension on the breaker bar.

7.Reinstall the mower deck guards.

8.Run the mower under no-load condition for about 5 minutes to break-in the new belt.

Figure 43. Mower PTO Belt

A.Idler Arm

B.Stationary Idler Pulley

D		B	C
A			A
	D	A

Figure 44. Mower PTO Belt Routing

A.Spindle Pulley

B.PTO Drive Belt

C.Spring-loaded Idler Pulley

D.Stationary Idler Pulley

34 www.SnapperPro.com