Snapper 5900683, 5900709, 5900734 Regular Maintenance, Hydraulic Pump Drive Belt Replacement

Hydraulic Pump Drive Belt Replacement

1.Park the tractor on a smooth, level surface such as a concrete floor. Disengage the PTO, engage the parking brake, turn off the engine, and remove the ignition key.

2.Remove the PTO drive belt (see MOWER BELT REPLACEMENT for removal instructions).

3.Loosen and remove the crankshaft bolt (C, Figure 45) and the PTO clutch (B) from the engine crankshaft.

WARNING

STORED ENERGY DEVICE: Improper release of the belt tension spring can result in personal injury.

Use extreme caution when removing this spring.

4.Loosen the nut on the spring anchor eyebolt (G, Figure 46) to release the majority of the belt tension. Use caution and remove the nut to completely release the tension.

A

B

C

Figure 45. Removing the PTO Clutch

A.PTO Clutch Mounting Tab

B.PTO Clutch

C.Crankshaft Bolt

Regular Maintenance

5.Remove the old belt and replace it with the new one. Make sure the V-side of the belt runs in the grooves of the crankshaft pulley and the transmission pulleys (B & C).

6.Reinstall the spring anchor eyebolt (G) into the anchor tab and loosely fasten the nut. Adjust the anchor eyebolt until a measurement of 5-7/8” (14,92 cm) is achieved from the outside if the spring hooks. Tighten nut.

7.Reinstall the PTO clutch to the engine crankshaft and secure with the crankshaft bolt. Tighten the crankshaft bolt to 65 ft. lbs (88 Nm).

NOTE: Make sure that the slot in the PTO clutch lines up with the PTO clutch mounting tab (A, Figure 45) underneath the engine deck.

8. Reinstall the PTO drive belt.

	B
	H
E	D
	A
C	C
	F
	G
5-7/8”
(14.92 cm)

Figure 46. Hydraulic Pump Drive Belt Replacement

A.Pump Drive Belt

B.Crankshaft Pulley

C.Pump Pulley

D.Idler Pulley

E.Idler Arm

F.Spring

G.Spring Anchor Eyebolt

H.Stationary Idler Pulley

Maintenance

35