Snapper 7-4510 manual Step Attach Cargo BED, Step Align Cargo BED Latch

STEP 10 (Continued)

INSTALL OPERATOR’S AND PASSENGER’S

SEAT

(3) SEAT BOLTS

1/2-13 X 3” BOLT & 1/2-13

NYLOC NUT

HINGE ROD

PROP ROD

1/2-13 X 3 3/4” BOLT & 1/2-13

NYLOC NUT

FIGURE 1.8

HAIRPIN

FIGURE 1.7

STEP 11

ATTACH CARGO BED

Attach bed to pivots at rear of frame. A prop rod is provided to support an empty cargo bed only in a raised position.

1.Align brackets on bottom rear of cargo bed with left and right pivots located at rear of frame. See Figure 1.8.

2.Insert (1) 1/2-13 x 3 3/4” bolt into each left and right pivot and secure with 1/2-13 NyLoc nuts. Tighten securely.

3.Attach prop rod to bracket on bottom of cargo bed using (1) 1/2-13 x 3” bolt and (1) 1/2-13 NyLoc nut. Tighten to a snug rotating fit.

5

STEP 12

ALIGN CARGO BED LATCH

Lower the Cargo bed slowly until the latch contacts the striker pin. The head of the striker pin should be inside of the latch as shown in figure 1.9. If it is not aligned correctly, loosen the bolts that attach the left and right bed pivot brackets. Then, position the latch over the striker pin as shown in figure 1.9 and re-tighten the bed pivot bracket bolts.

LATCH ASSEMBLY

STRIKER

PIN

FIGURE 1.9