Troubleshooting, Adjustment,& Service
TROUBLESHOOTING
WARNING
This section provides troubleshooting and service instructions. Locate the problem and check the possible cause/remedy in the order listed.
Also, refer to the engine manufacturer's Owner's Manual for additional information.
Before performing any adjustment or service to snowthrower, stop the engine and wait for moving parts to stop. Remove the key. To prevent accidental starting, disconnect the spark plug wire and fasten away from the plug.
For problems not covered here, contact your local deal- er.
PROBLEM |
|
| POSSIBLE | CAUSE |
| REMEDY | |
Engine fails to start. | 1. | Key | is OFF. |
| 1. | Push key in to the ON position. | |
| 2. | Failure | to prime cold | engine | 2. | Press Primer Button twice and restart. | |
| 3. | Fuel | valve is in CLOSED position. | 3. | Turn valve to OPEN position. | ||
| 4. | Out | of fuel. |
| 4. | Fill fuel tank. | |
| 5. | Choke OFF - cold engine. | 5. | Turn choke to ON, set throttle to | |||
|
|
|
|
|
|
| FAST. |
| 6. | Engine | flooded. |
| 6. | Turn choke to OFF; try starting. | |
| 7. | Spark | plug not sparking. | 7. | Check gap. Gap plug, clean elec- | ||
|
|
|
|
|
|
| trode, or replace plug as necessary. |
| 8. | Water | in fuel, or old fuel. | 8. | Drain tank (Dispose of fuel at an | ||
|
|
|
|
|
|
| authorized hazardous waste facility). |
|
|
|
|
|
|
| Fill with fresh fuel. |
Engine starts hard or runs poorly. | 1. | Fuel mixture too rich. |
| |
| 2. | Carburetor adjusted incorrectly. | ||
| 3. | Spark plug faulty, fouled, | or gapped | |
|
| improperly. |
|
|
| 4. | Fuel cap vent is blocked. |
| |
Auger does not rotate. | 1. | Auger control | not engaged. | |
| 2. | Foreign matter | blocking | auger. |
3. Auger drive clutch cable slack.
4. Auger drive belt slipping.
5. Broken belt.
6. Shear pin broken.
1.Move choke to OFF position.
2.See your dealer for adjustments.
3.Clean and gap, or replace.
4.Clear vent.
1.Engage auger control.
2.STOP engine and REMOVE the key. DISCONNECT the spark plug wire. Clear auger using
3.Tighten to remove slack. See auger clutch cable adjustment.
4.Check auger drive belt adjustment.
5.Replace belt.
6.Replace shear pin.
20