Adjustments & Service
| A |
|
B |
| D |
|
| B |
| C | A |
|
| |
|
| D |
Figure 27. Spout Rotator Rod
A.Special Nut
B.Cover
C.Hair Pin
D.Spout Rotator Rod
A |
A |
B |
B |
Figure 28. Install Spout Rotator Rod
A.Hex Dash Opening
B.Spout Rotator Rod
15.Index or point the spout rotator to the center of the machine so the rotator control is in the center of the dash panel.
16.Slide spout rotator rod (B, Figure 28) into hex dash opening (A).
17.Insert hair pin (C, Figure 27) into spout rotator rod
(D).
18.Install cover (B) and secure with special nut (A).
19.Install the auger drive belt (D, Figure 26) onto the impeller pulley (H).
20.Slip the auger drive belt (D) under the idler pulley (K).
21.Adjust the auger drive belt. See “How To Adjust The Auger Drive Belt” in the Service section.
22.Adjust the belt guide. See “How To Adjust The Belt Guide” in the Service section.
23.Install the belt cover (A, Figure 21). Tighten screws
(B).
24.Check the adjustment of the cables. See “How To Check And Adjust The Cables” in the Adjustment section.
25.Install the bottom panel (B, Figure 25).
26.Tighten the capscrews (A) on each side of the bottom panel (B).
27.Connect the spark plug wire.
| A |
| B |
D | C |
|
Figure 29. Frame and Axle Housing
A.Upper Capscrews
B.Lower Capscrews
C.Auger Housing
D.Frame
29
