Section 5 - ADJUSTMENTS & REPAIR
5.8ENGINE ADJUSTMENTS & REPAIR
Refer to the engine owner’s manual for engine adjustments and/or repairs.
5.9MOWER BLADE REPLACEMENT 5.9.1. BLADE WEAR LIMITS
1.Inspect blade frequently for signs of excessive wear or damage. Replace blade when it reaches the wear limit. See Figure 5.14.
5.9.2. BLADE SHARPENING
1.Remove blade. See Figure 5.15.
2.Inspect condition of blade. See Figure 5.14.
3.If blade is in good condition, sharpen at 22 to 28 degrees. DO NOT sharpen beyond original cutting edge. See Figure 5.16.
4.Check blade balance after sharpening. If necessary, correct blade balance by grinding the heavy end of blade.
IMPORTANT: Blade balancing should be performed by a qualified dealer.
5.Reinstall blade. See Figure 5.15. Torque blade mounting nuts to recommended range of 70 to 80 ft. lbs.
SPINDLE
ASSEMBLY
BLADE
CONE
WASHER
BLADE MOUNTING NUT
FIGURE 5.15
NEW BLADE
BLADE
22º TO 28º
ORIGINAL CUTTING EDGE
WEAR LIMIT (NOTCH STARTS)
DANGEROUS CONDITION! DO NOT USE ON MOWER! REPLACE WITH NEW BLADE.
FIGURE 5.16
FIGURE 5.14
24