![](/images/new-backgrounds/1167320/16732011x1.webp)
250 Z & Javelin Series
Uncrating
1.Using a reciprocating utility saw or equivalent, cut crate away from bottom skid. Remove crate. Remove plastic wrap.
2.Cut any banding securing the unit.
IMPORTANT NOTE
When cutting crate from bottom skid, use caution around tires and mower rollers.
3.Place transmissions in the roll release position by pushing the roll release rods (A, Figure 1), located under the rear of the unit behind each transmission, in toward the transmission until the collar on the neck of each rod passes through the keyhole in the roll release plate (B). Then lock the rod in the roll release position by sliding the rod sideways into the keyhole slot.
4.Move the motion control levers from their neutral locked positions.
The rider can now be pushed by hand.
A |
B |
Figure 1. Roll Release Components (On Each Side)
A.Roll Release Rod
B.Roll Release Plate
5.Be sure there are no nails or sharp objects on the bot- tom of the skid to puncture the tires. Roll the rider for- ward off the skid.
6.After moving the rider, move the motion control levers back into their neutral locked positions, and re- engage the transmissions (drive position) by unlock- ing the roll release rods and pulling them out.
TP | 6 | 10/2006 |