250 Z & Javelin Series
Perform
Safety Checks
WARNING
Disengage the PTO, stop the engine, move both motion control levers into their neutral locked positions, and wait for moving parts to stop before leaving operator's position for any reason.
If the unit does not pass the test, do not operate it. Under no circumstance should you attempt to defeat the purpose of the safety system.
Burnish PTO Clutch
1.Select a safe area to operate the mower deck. With the motion control levers locked into their neutral locked positions, the PTO switch disengaged, and an operator in the seat, start the engine. Run the engine at full speed.
2.Engage the PTO switch and run the deck for fifteen seconds. Disengage the PTO switch and wait for the mower drive belt to stop.
3.Repeat step 2 above ten times, and then
Functional Tests
1.Check for loose bolts, screws, nuts, etc.
2.Start the engine and check all controls for proper operation: motion control levers, engine speed and choke cables, electric PTO clutch, cutting height adjustment lever, etc.
3.Stop the engine and check for fluid leaks: oil, gaso- line, or transmission oil.
4.If any control fails to operate properly during testing or seems to be out of adjustment, check and readjust it according to the following Adjustments section.
4. Turn the key to OFF to end the demonstration.
Mower Blade Stopping Check
Mower blades and mower drive belt should come to a complete stop within five seconds after the electric clutch switch is turned off.
With the motion control levers locked into their neutral locked positions, the electric clutch switch disengaged, and an operator in the seat, start the engine. Run at full speed. Engage the electric PTO clutch switch and wait several seconds. Disengage electric clutch switch and check the time it takes for the mower drive belt to stop. If the mower drive belt does not stop within five seconds, adjust the PTO clutch according to the instructions in the Electric Clutch Adjustment section.
Seat Switch Connection
Check that the seat switch wire harness (C, Figure 7) is connected to the seat switch.
TP | 10 | 10/2006 |
