Snapper ELT145H33FBV important safety instructions Adjustment & Repair

Models: ELT145H33FBV

1 40
Download 40 pages 42.18 Kb
Page 22
Image 22
Manual background

Section 4 - ADJUSTMENT & REPAIR

4.3TRACTOR DRIVE COMPONENTS 4.3.1. BRAKE ADJUSTMENT

1.To be properly adjusted, the brake should stop the tractor in approximately 6 feet from top speed when the clutch/brake pedal is fully depressed.

2.Adjust brake when necessary as follows:

3.Turn engine “OFF”. Remove key.

4.Locate brake adjustment nut underneath the rear of tractor. See Figure 4.13.

5.Turn nut clockwise to increase braking action or counterclockwise to decrease braking action.

6.Start engine and test brake.

7.Continue adjustment as described above until proper adjustment is achieved.

FUEL TANK

ROTATE TO

LESSEN “PLAY”

ECCENTRIC MOUNTING NUT

FIGURE 4.14

 

 

3.

Loosen the eccentric mounting nut and rotate the

 

 

eccentric clockwise until steering “Play” is reduced.

 

 

Refer back to Figure 4.14.

 

 

 

4.

Tighten eccentric mounting nut.

 

ROTATE ADJUSTING NUT CLOCKWISE TO

 

 

INCREASE BRAKING OR COUNTER

4.3.3. SHIFTER ADJUSTMENT

 

If movement of tractor does not correspond with the

CLOCKWISE TO DECREASE BRAKING

 

 

selected speed on shift quadrant, adjust the speed

FIGURE 4.13

control lever as follows:

 

1.

With engine running, drive tractor and move shift

 

 

 

 

lever to locate neutral.

 

WARNING

 

 

 

2.

Turn engine “OFF”. Remove key.

 

DO NOT attempt any adjustments, maintenance or

 

3.

Locate speed control lever mount behind right

service with the engine or blade running. STOP blade.

 

rear tire. See Figure 4.15.

 

STOP engine. Set brake. Remove key. Remove spark

 

 

 

 

plug wire from spark plug and secure wire away from

 

 

 

SPEED

spark plug. Engine and components can be extremely

 

SPEED CONTROL

CONTROL

hot. Avoid burns by allowing engine and components

 

LEVER

 

LEVER MOUNT

 

 

sufficient time to cool.

 

 

 

 

 

 

 

 

 

4.3.2STEERING ADJUSTMENT

Should excessive “Play” be noted in the steering, adjust as follows:

1.Turn engine “OFF”. Remove key.

2.From left side of tractor, locate the steering sector below fuel tank. See Figure 4.14.

MOUNTING NUTS

FIGURE 4.15

(Continued on next page)

22

Page 22
Image 22
Snapper ELT145H33FBV important safety instructions Adjustment & Repair