26
Regular Maintenance
Figure 29. Oil Drain Valve
A. Engine Block / Valve Base
B. Oil Drain Valve
C. Cover
D. Nipple
AA
BB
CC
D
Oil Drain Valve Operation
1. Place a suitable container with a 4 quart capacity
under the oil drain valve (A, Figure 26 or 27).
2. Loosen or remove the dipstick (C).
3. Wipe oil drain valve (B, Figure 29) and cover (C) with
paper towel or rag.

NOTE: Sliding a hose with a 1/2” (12.5 mm) inside

diameter tube over the valve nipple may aid in guiding

the draining oil.

4. Rotate the oil drain valve (B) counterclockwise and
pull out 1/4” (6.35 mm) for engine oil to drain. Allow
ample time for complete drainage.
5. After all the oil has drained, close the oil drain valve
(B) by pushing in and rotating clockwise to close.
6. Wipe the nipple (D) with paper towel or rag. Install
the cover (C) over nipple (D).
Change Engine Oil
BRIGGS & STRATTON MODELS
Service Interval: 50 hours or once per season.
Oil Capacity: Approximately 1-7/8 quarts (1.8 L) without
filter change.

NOTE: Change engine oil while the engine is warm. Run

the engine for a few minutes, then shut the engine off

and allow it to cool from hot to warm.

1. Clean the area around the dipstick (C, Figure 26 or
27) and oil drain valve (A).
2. Drain engine oil. See OIL DRAIN VALVE
OPERATION above.
3. Fill the crankcase with oil. See CHECK ENGINE OIL
LEVEL.
Change Engine Oil & Filter
BRIGGS & STRATTON MODELS
Service Interval: 100 hours or once per season.
Oil Capacity: Approximately 2 quarts (1.9 L) with oil filter
change.

NOTE: Change engine oil while the engine is warm. Run

the engine for a few minutes, then shut the engine off

and allow it to cool from hot to warm.

1. Clean the area around the dipstick (C, Figure 26 or
27) and oil drain valve (A).
2. Drain engine oil. See OIL DRAIN VALVE
OPERATION above.
3. Remove the oil filter (B). Discard the filter.
4. Using a drop of oil on your finger tip, wet the rubber
gasket on the bottom of the new filter.
5. Turn the filter clockwise until the rubber gasket meets
the filter base. Then turn filter an additional 1/2 to 3/4
turn.
6. Fill the crankcase with oil. See CHECK ENGINE OIL
LEVEL.
7. Test run the engine to check for leaks. Stop the
engine for 1 minute, then recheck the oil level.
Valve
Closed
Valve
Open