Snapper LT23460AWS specifications Installing the Seat, Assembling the Steering Wheel

Installing the Seat

How to Install the Seat

1.Carefully remove the plastic bag from the seat. Use the fasteners shown below to install the seat. The fasteners are shown at full size.

A B

Figure 4: Seat parts

A - Wing bolt (Also see ‘E’ in Figure 3)

B - Washer (Also see ‘F’ in Figure 3)

NOTE: Fasteners may be attached to seat for shipping purposes, if so remove fasteners before proceeding.

2.Align the holes in the seat hinge to the holes in the seat (Figure 5). Fasten the seat to the seat hinge with the fasteners as shown.

3.Check the operating position of the seat. If the seat needs to be adjusted, loosen the two wing bolts. Slide the seat forward or backward along the seat adjusting holes as shown. Tighten the wing bolts (A).

E
D
C	B
	A

Figure 5: Seat

A - Wing bolt

B - Washer

C - Seat adjusting hole

D - Seat hinge

E - Seat

English

Assembling the Steering Wheel

How to Assemble the Steering Wheel

Tools Required: 3/8" Socket Wrench

Attach the steering wheel as follows:

A

B

Figure 6: Steering wheel parts

A - Screw (Also see ‘C’ in Figure 3)

B - Washer (Also see ‘D’ in Figure 3)

1.Make sure the front wheels point forward.

2.Slide the bellows over the steering post (Figure 7).

NOTE: Before attachment of the steering wheel, make sure that the front wheels point forward and are straight. For proper alignment of the steering wheel, see Figure 7.

3.Slide the steering wheel onto the steering post.

4.Use the fasteners shown above to secure the steering wheel. The fasteners are shown at full size. Tighten the screw until snug and then add 1/4 turn. DO NOT over tighten.

5.Attach the cover to the steering wheel.

6.Some models have an optional decal in the parts bag. Attach the decal to the center of the steering wheel as shown.

en

9