Snapper 5/14, 8/14, SAC55140BV manual Troubleshooting & Repair, Symptom, Possible Cause, Remedies

Troubleshooting & Repair

TROUBLESHOOTING

While normal care and routine maintenance will extend the life of your chipper/shredder, prolonged or constant use may eventually require that service be performed to allow it to continue operating properly. The troubleshoot- ing guide below lists the most common problems, causes and remedies.

See the service information on the following pages for instructions on how to do most of these minor repairs yourself. If you prefer, all of these procedures can be performed for you by your local authorized dealer.

WARNING

Never attempt to perform any of these proce- dures with the engine running. Always turn the engine off, let the rotor come to a complete stop, and disconnect the spark plug wire from the spark plug before attempting to correct any operating problems.

Failure to comply with this safety requirement can result in serious personal injury to you or bystanders.

SYMPTOM	POSSIBLE CAUSE	REMEDIES
Engine won’t start.	• Out of gas.	•	Add gas.
	• Spark plug wire disconnected.	•	Connect spark plug wire.
	• Engine controls set wrong.	•	Check engine controls and
			adjust.
	• Spark plug fouled.	•	Remove Spark Plug, clean, and
			replace.
	• No compression - rope pulls•	•	See your local dealer.
	without resistance.
	• No spark - electrical system	•	See your local dealer.
	problem.
Engine runs, but rotor.	• Crankshaft key broken or not	•	Replace crankshaft key.
won’t turn.	installed.
Engine runs, rotor turns, but no	• Discharge chute clogged.	•	Clear discharge chute.
material is being discharged.	• Engine not running at full RPM.	•	Adjust throttle to “Fast”.
Excessive branch vibration when	• Chipper knives dull.	•	Sharpen or replace knives.
chipping materials.	• Tree limbs and branches are	•	Material too dried out or hard
	extremely hard or dried out.		for chipping - use for firewood.
Unusual noise or vibration when	• Rotor overloaded with material.	•	Allow unit to clear itself before
processing material.			feeding more material in .
	• Non-organic matter caught in	•	Follow shut-down procedure and
	shredding chamber.		remove material from unit.
	• Chipper knives dull or loose.	•	Sharpen or tighten knives secure
			ly.
	• Hammers, broken, bent, or loose.	•	Check for proper assembly or
			replace.
	• Hammers frozen on shaft.	•	Check for obstructions and
			remove debris from hammer
			pivot areas.
	• Crankshaft bent.	•	See your local dealer for
			factory authorized repair.
Vacuum not working.	• Hopper lid not in place.	•	Replace lid on hopper.
	• Material too wet.	•	Allow material to dry.
	• Hose not attached properly.	•	Attach hose per kit instructions.
	• Hose obstructed/damaged.	•	Inspect hose - repair or replace.
	• Engine not running at full RPM.	•	Set throttle to “Fast”. See dealer
			if problem continues.

20