#7600029 TRIPLE BAG CATCHER KIT FOR
44 & 50” SNAPPER / SIMPLICITY RZT RIDING MOWERS
! | WARNING | ! |
DO NOT attempt any adjustments, maintenance, repairs, or service with engine running. Stop engine. Engage parking brake. Remove key. Remove spark plug wire and secure wire away from spark plug. Engine, muffler and surrounding areas are extremely hot. Avoid serious burns; allow components to cool down before installing kit. Replace worn or damaged parts prior to operating. Use approved fuel container. DO NOT smoke near open fuel container. DO NOT fill fuel tank indoors or when engine is running. Allow engine to cool for at least ten minutes before refilling. Make sure that fuel cap is tightened securely. Wipe off any spilled fuel before starting engine.
STEP 1: Remove the two innermost front carriage bolts securing the unit footrest to the frame. Install the seven ballasts against the front of the machine, securing with the supplied 5/16 x
REMOVE EXISTING HARDWARE
a. Measure the baffles to determine which are needed. See Figure 2.
b. Secure the left baffle to the inside front of the deck with four 5/16 x 5/8” carriage bolts and flange nuts. See Figure 3. c. Secure the right baffle to the inside front and bottom of the deck with three 5/16 x 5/8” carriage bolts and flange nuts. See Figure 3. Be sure to tighten all hardware securely.
LOCK
NUT (2)
BALLASTS (7)
CARRIAGE BOLTS
FIGURE 1
STEP 2: Install the baffles to the inside front of the mower deck:
NOTE: Prior to installation, remove any existing baffle(s) that may be installed to the inside front of the deck.
FIGURE 3
(Components removed for clarity)
STEP 3: Raise the discharge deflector. See Figure 4.
RIGHT BAFFLE
| LEFT BAFFLE |
|
|
|
|
|
| RAISE |
|
|
|
| DEFLECTOR |
|
|
|
|
| FIGURE 4 |
|
|
|
| |
|
|
|
| INSTRUCTION No. 7101095 (I.R. 9/19/2006) |
FIGURE 2 |
|
|
| TP |
1
