Snapper Simplicity RZT Riding Mowers manual Attach to ALL ‘A’ Locations see Figure

STEP 12: Assemble the discharge tubes:

a. Install one strap assembly to each of the locations marked ‘A’ in Figure 16. Insert one #10-24 x 5/8” pan head screw, fitted with one #10 x 1/2” OD flat washer, out through the hole in the tube or adapter. Secure with one #10 x 3/4” OD flat washer, strap, and #10-24 tee nut, tightening securely. See Figure 14.

ATTACH TO ALL ‘A’ LOCATIONS (SEE FIGURE 19)

FIGURE 16

c. Install the large end of the lower tube (short, straight tube) onto the end of the adapter, and secure the strap on the tube to the tee nut on the adapter. See Figure 17.

d. Intall the curved end of the upper tube into the hole in the cover assembly, making sure the discharge faces toward the left of the unit. Install the bottom of the upper tube onto the top of the lower tube, and secure the two straps on the upper tube to the two tee nuts on the lower tube. See Figure 17.

FIGURE 14

b. Install one tee nut assembly to each of the locations marked ‘B’ in Figure 16. Insert one 5/16 x 5/8” pan head screw out through the hole in the tube or adapter. Secure with one 5/16” flat washer and 5/16-18 tee nut, tightening securely. See Figure 15.

ATTACH TO ALL ‘B’ LOCATIONS (SEE FIGURE 19)

INSTALL

UPPER TUBE INTO COVER ASSEMBLY, THEN OVER LOWER TUBE

COVER

ASSEMBLY

DISCHARGE SHOULD

FACE TOWARD LEFT

SIDE OF UNIT

SECURE

STRAPS TO

‘T’ NUTS

(3 PLACES)

INSTALL

LOWER TUBE

OVER

ADAPTER

FIGURE 15

FIGURE 17

4