STEP 13: Assemble the grass containers:

a. Match each container section with its corresponding sections (see Figure 18):

Container 1

A1, A2, A3

Container 2

B1, B2, B3

Container 3

A1, A2, A3 (or B1, B2, B3).

b. With the matched numbers aligned, insert the bottom section (A3, B3) of each container through the middle section (A2, B2), and the middle section through the top section (A1, A1), until the tabs around the top of each section lock the section in place. See Figure 18.

SLIDE

CONTAINERS

ONTO

TUBES

CONTAINER 1

COVER HANDLE

SHOULD LOCK ONTO

CONTAINERS WHEN

COVER IS CLOSED

CONTAINER 3

WARNING LABELS CONTAINER 2 FACING

OUT

TABS

CONTAINER 1

MATCH & ALIGN NUMBERS

CONTAINER 2

 

CONTAINER 3

FIGURE 20

When closing the cover, make sure that the cover handle locks under the lips of the containers.

Assembly is complete.

Operation:

FIGURE 18

c. With the containers assembled, firmly insert one plastic fastener out through the aligned holes in all four sides where the top and middle sections meet. See Figure 19.

INSERT FASTENERS (4 PER CONTAINER)

FIGURE 19

STEP 14: Flip open the cover assembly, then slide each container fully onto the U-tube assembly. See Figure 20. NOTE: Make sure that the warning label on the side of each container is facing out.

!

WARNING

!

To prevent injury or damage, always follow the operating instructions supplied with your machine when operating the bagger.

To use the bagger: -Start the engine.

-Move the throttle control to the fast position.

-To fill the containers, always operate at a slow ground speed.

To check and clean the discharge tubes:

-Stop machine motion, turn off the blades, stop the engine. -Disconnect the straps securing the discharge tubes, and remove the tubes.

-If needed, clear the discharge tubes of clogged debris, and clean with soap and water.

-Replace the discharge tubes.

To empty the containers:

-Stop machine motion, turn off the blades, stop the engine. -Pull the cover handle back and raise the cover.

-Remove the containers and empty as needed.

NOTE: For easy removal of grass, use a 33 gallon plastic lawn bag inside each container.

5

Page 5
Image 5
Snapper Simplicity RZT Riding Mowers manual Assembly is complete Operation