! IMPORTANT OPERATOR SAFETY INSTRUCTIONS (Continued) | ! |
SAFE HANDLING OF GASOLINE (Continued From Previous Page)
7.Remove
8.DO NOT start gas powered equipment in enclosed vehicles or trailers.
9.Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. DO NOT use a nozzle
10.If fuel is spilled on clothing, change clothing immediately.
11.DO NOT overfill a fuel tank. Replace fuel cap and tighten securely.
OPERATION
1.DO NOT put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.
2.STOP engine when crossing gravel drives, walks, or roads, and under any conditions where thrown objects might be a hazard.
3.Mow only in daylight or good artificial light.
4.DO NOT operate mower while under the influence of alcohol or drugs.
5.After striking a foreign object or if mower vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the mower for any damage and repair the damage before starting.
6.DO NOT mow near drop offs, ditches or embankments. Operator could lose footing or balance.
7.STAY ALERT for holes and other hidden hazards. Tall grass can hide obstacles. Keep away from ditches, washouts, culverts, fences and protruding objects.
8.DO NOT mow on wet grass. Always be sure of your footing. Keep a firm hold on the handle and walk, never run. Slipping could cause injury.
9.ALWAYS stay behind handle when engine (motor) is running.
10.DO NOT leave the machine with the engine running. STOP BLADE and STOP ENGINE before leaving the operators position for any reason.
11.Before cleaning, repairing or inspecting make certain engine, blade and all moving parts have STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.
12.STOP engine and wait until the blade comes to complete STOP before removing grass bag and/or clearing grass.
13.DO NOT operate mower without the entire grass catcher, or guards in place discharge guard, rear guard or other safety devices in place and working. DO NOT point discharge at people, passing cars, windows or doors.
OPERATION
(Continued From Previous Column)
14.DO NOT discharge material against a wall or
obstruction. Material may ricochet back towards the operator.
15.Slow down before turning.
16.Watch out for traffic when near or crossing roadways.
17.DO NOT operate engine in enclosed areas. Engine
exhaust gases contain carbon monoxide, a deadly poison.
18.Only use accessories approved by the manufacturer. See manufacturer’s instructions for proper operation and installation of accessories.
MAINTENANCE AND STORAGE
1.DO NOT store mower or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of reach of children in a well ventilated, unoccupied building.
2.Keep mower and engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.
3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.
4.Keep all bolts, especially blade bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.
5.Always provide adequate ventilation when running engine. Engine exhaust gases contain carbon monoxide, a deadly poison.
6.Service engine and make adjustments only when engine is stopped. Removed spark plug wire from spark plug and secure wire away from spark plug to prevent accidental starting.
7.DO NOT change engine governor speed settings or overspeed engine.
8.Check grass bag assembly frequently for wear or deterioration to avoid thrown objects and exposure to moving parts. Replace with new bag if loose seams or tears are evident. Replace slider or bag adapter if broken or cracked.
9.Mower blades are sharp and can cut. Wrap the blades or wear heavy leather gloves and use CAUTION when handling them.
10.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.
11.Have machine serviced by an authorized SNAPPER dealer at least once a year and have the dealer install any new safety devices.
12.Use only genuine SNAPPER replacement parts to assure that original standards are maintained.
Operator Safety
3
