Snapper ZT3000 Rider Assembly, Seat & Safety Switch Assembly, Install Ground Speed Control Levers

Simplicity / Snapper ZTR

Rider

Assembly

Seat & Safety Switch Assembly

1.Mount the seat (A, Figure 3) to the seat plate (B) using four 5/16-18 nylock flange nuts (C) and tighten securely.

2.Connect the seat switch wire harness (D) to the seat switch.

Install Ground Speed Control Levers

1.Mount the ground speed control levers (D, Figure 4) to the control lever base (E) using four 5/16-18 x 1” bolts, lockwashers, and washers (A, B & C).

NOTE: Before operating the unit the ground speed control levers and seat must be adjusted to fit the operator. See SEAT ADJUSTMENTS and GROUND SPEED CONTROL LEVER ADJUSTMENTS in the Adjustments section.

B

A

C

D

C

Figure 3. Seat Installation

A.Seat

B.Seat Plate

C.5/16-18 Nylock Flange Nut (4)

D.Seat Switch Wire Harness

A	B	C
E
D

Figure 4. Install Control Levers

A.5/16-18 x 1” Bolts

B.5/16 Lockwashers

C.5/16 Washers

D.Control Lever

E.Control Lever Base

8/2007 5 TP 300-7337-01-CH-SMN