Simplicity / Snapper ZTR
Roller Bar Leveling
(select models)
The rollers on this Zero Turn unit are not intended to ride on the ground. DO NOT adjust rollers to ride on the ground. Rollers riding on the ground will damage turf and or unit.
1.First level the mower deck using the procedure found in MOWER DECK LEVELING.
2.With the mower installed, place the rider on a smooth, level surface such as a concrete floor. Turn the front wheels so they are straight.
3.Place the mower cutting height pin in the 4th hole from the bottom (C, Figure 20).
4.Measure the distance between the outside ends of the roller bar and the ground. If there is more than 1/8” (3mm) difference between the measurements on each side, proceed to step 5.
5.Locate the roller bar leveling eccentric and locknuts (A, Figure 22). Loosen the locknut and turn the eccentric to raise or lower a side. When the correct level is achieved, hold the eccentric with a wrench and tighten the locknut. Repeat step 4 if necessary.
A |
Figure 22. Roller Bar Leveling
A. Eccentric and Locknut
TP | 16 | 8/2007 |
