INSTALLATION
For convenient installation, these Snell AMC series speaker systems use a
1)Make an appropriate size speaker mounting cutout in the wall material.
2)Run the wire from the amplifier to the cutout. Allow an extra foot of wire at the cutout. Strip 1/2” (12mm) off the wire, and tightly twist the wire strands together.
3)Remove the speaker grille.
4)Insert the speaker wires into the spring terminal binding posts.
Important: Typically, one side of the wire is smooth. Connect this side to the – (black)
speaker terminal. The other side has a rib or stripe. Connect this to the + (red) speaker terminal. Connect wire at the amplifier in the same way. Failure to do so will result in degraded sound.
Warning! To prevent electrical shock, always switch off the amplifier or receiver when making connections to the speaker system.
5)Place the speaker into the rough opening.
6)Level the speaker and tighten the screws, being careful not to over tighten them. See dia- gram below for details.
7)Replace the speaker grille.
Turn the mounting clamps against the enclosure, then place the speaker in the mounting hole. Use a phillips head screwdriver to deploy the mounting clamps and pull them against the back of the drywall.
8
