4.To obtain a desirable temperature, there is an area indicated on the Temperature Control Knob known as the “Comfortable Zone.” You can adjust the knob to select a temperature within this range.
5.
This setting keeps the temperature of the surrounding area above freezing to prevent pipes from breaking. To do this, simply plug in the heater and turn the Temperature Control Knob to the “Snowflake” position. The heater will automatically turn on when the ambient temperature drops below 41°F.
6.Economic Energy Saving Function (ECO)
When the room temperature reaches a certain point, the ECO Green Light will switch on, indicating that
[ our 1500 Watt heater will work on 1000 Watts]
7.Overheat Safety Protection
The heater comes equipped with overheat safety protection, so it can detect if it is overheating and will automatically shut off. When the unit temperature falls again, power will be resumed. To avoid overheating and potential risk of fire, DO NOT cover the heater.
Important Safeguards
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER !
¾The heater is hot when in use. To avoid burns, do not let bare skin touch hot surface. Use handles when moving this heater.
Keep combustible materials, such as drapery and other furnishings, at least 3 feet [0.9m] from the front of the heater and away from the sides and rear.
¾Extreme caution is necessary when any heater is used by or near children or invalids, or when the heater is left operating or unattended.
¾Do not use outdoor. Never locate heater where it may fall into a bathtub or other water container.
¾This heater has hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint or flammable liquids are used or stored.
¾Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
¾To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not operate this appliance on soft surfaces because the inlet openings can be blocked.
¾Always unplug heater when not in use. To disconnect heater, turn controls to off, then remove plug from outlet.
¾Avoid using an extension cord because the extension cord may overheat and cause a risk of fire. However, if an extension cord must be used, the conductor wire inside the cord must be No.14 AWG minimum size and rated not less than 1875 watts.
¾Do not run cord under carpet and do not cover cord with throw rugs, runners, or the like. Place the cord away from traffic area and where it will not be tripped over.
¾The heater must not be located immediately below an outlet.
¾Do not operate any heater with a damaged cord or plug, after the heater malfunctions, or has been dropped or damaged in any manner. If the heater is damaged, it must be serviced by the manufacturer or a similarly qualified service agent in order to ensure safety.
¾Connect the heater to properly grounded outlets only.
¾Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
