Installation
Required tools for use on floor:
phillips screwdriver (not included)
Required tools for wall mounting:
phillips screwdriver (not included) drill (not included) hammer (not included)
A.On the floor
Insert the feet and bolts onto the unit as shown in the diagram.
B.On the wall
STEP 1
Using the mounting support as a guide, mark the first screw hole on the wall.
STEP 2
Drill first hole.
STEP 3
Insert first screw anchor into the first hole.
STEP 4
Put mounting support on the wall and tighten it lightly.
STEP 5
Mark second screw hole on the wall [approximately 5 7/16 in.].
STEP 6
Drill second hole.
STEP 7
Insert second screw anchor into the second hole.
STEP 8
Tighten both screws.
Operation
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER !
1.Ensure that the Temperature Control Knob is at “DOT” position. [Fig 1]
Also, make sure the power switch is at the off position. [Fig 2]
2.Plug the power cord into a suitable electrical outlet. [Rated not less than 115 volt]
3.Turn the power switch to the “ON” position, then adjust the Temperature Control Knob clockwise until the Red Light Indicator turns on [Fig 2]. At this moment, the Temperature Control will start working.
Note: The Red Light Indicator will turn off when the room reaches the desired temperature. After a while, as the room temperature falls, the heater will turn on again and release heat until the room temperature rises to the desired temperature. Desired room temperature is maintained automatically by this procedure.
You can adjust the temperature control knob to increase or decrease the room temperature as desired by turning in a clockwise or
