Tannoy 18DR, 15, 12 HP Important It is imperative for safety reasons that two, These fittings

14.4 : SECUR ET - VEB EYEBOLT

FIG 1.		The Tannoy VNET“ loudspeaker can be flown with high quality
		VEB M10 eyebolts with collar to BS4278:1984. The loudspeakers
		are equipped with internal steel braces, which also double as the
		flying points, and accept VEB M10 eyebolts.
		To install the VEB M10 eyebolts remove the original M10 counter
		sunk screws from the locations you wish to install the VEB M10
		eyebolts. Then replace these counter sunk M10 screws with the VEB
		M10 eyebolts. The M10 insert on the rear of the cabinet also accepts
		a VEB M10 eyebolt and should only be used for tilting the loudspeaker
		to the desired angle.
			Important: It is imperative for safety reasons that two
			eyebolts linked to two independently fixed straps are
			used per cabinet. VEB eyebolts should be installed
			into the relative sides of the cabinet, and should NEVER
			be installed on the top of the cabinet. Never suspend
		one enclosure from another to form a line array or cluster using
		these fittings.
		The correct method is shown in figure 2.
		Never attempt to use formed eyebolts i.e. formed from a steel
		rod and bent into an eye.
		Only use the outer fixing points on the top and sides of the VNET“
		cabinet for fixing eyebolts. The inner two fixing points on each side
		of the cabinet are for dedicated bracketry (VMY) only.
	.
				FIG 2.

p r o f e s s i o n a l

p r o f e s s i o n a l

p r o f e s s i o n a l

p r o f e s s i o n a l

TM

29