Location Requirements
IMPORTANT: Observe all governing codes and ordinances. Check the location where the air conditioner will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation.
The location should provide:
•Grounded electrical outlet within 4 ft (122 cm) of where the power cord exits the air conditioner.
NOTE: Do not use an extension cord.
•Free movement of air in room to be cooled.
•A large enough opening for the air conditioner. Installation parts are supplied for
•Adequate wall support for weight of air conditioner. Air conditioner weighs 51 lb (23 kg) to 65 lb (29.5 kg).
NOTES:
•Cabinet louvers must not be obstructed. Air must be able to pass freely through the cabinet louvers.
•Your model may differ from the one shown.
A
A. Cabinet louvers
Window Installation
Window opening measurements:
o25" (63.5 cm) minimum to 38" (96.5 cm) maximum opening
width
o14" (35.6 cm) minimum opening height
A
B
A. 25" (63.5 cm) minimum
B. 14" (35.6 cm) minimum
4
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet. Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
The electrical ratings for your air conditioner are listed on the model and serial number label. The model and serial number label is located behind the front panel above the coil area.
Specific electrical requirements are listed in the chart below. Follow the requirements for the type of plug on the power supply cord.
Power supply cord | Wiring requirements |
o 115 volt (103.5 min.- | |
| 126.5max.) |
o | |
o
o Use on single outlet circuit only.
