Soleus Air KC-15U Air Conditioner Use, Starting Your Air Conditioner- Digital Control, Mode

AIR CONDITIONER USE

Operating your air conditioner properly helps you to obtain the best possible results.

This section explains proper air conditioner operation.

IMPORTANT:

•If you turn off the air conditioner, wait at least 3 minutes before turning it back on. This prevents the air conditioner from blowing a fuse or tripping a circuit breaker.

•Do not try to operate your air conditioner in the cooling mode when outside temperature is below 65°F (18°C). The inside evaporator

coil will freeze up, and the air conditioner will operate properly.

NOTE: In the event of a power failure, your air conditioner will operate at the previous settings when the power is restored.

Starting Your Air Conditioner—

Digital Control

NOTE: When the air conditioner is off, the display will show the current room temperature.

1.Press POWER to turn on air conditioner.

NOTE: When air conditioner is turned on for the first time

after it is plugged in, it will display the default settings: Cool mode, Turbo fan speed, 72ºF (22ºC). When it is turned on at all other times, it will default to the previous settings.

2.Select mode. See “Mode.”

3.Select fan speed. See “Fan Speed.”

4.Set temperature. See “Temperature.”

Mode

1.Press MODE until you see the indicator light come on for the desired setting.

2.Choose Cool, Fan Only or Power Saver.

oCool—Cools room. You can select fan speed by pressing FAN SPEED. You can then adjust the temperature by pressing the up or down arrow buttons.

oFan Only—Only the fan runs. You can select the fan speed by pressing FAN SPEED, but you cannot adjust the Temperature control setting. The display shows the current room temperature.

NOTE: Auto fan speed cannot be selected in Fan Only mode.

•Power Saver—Fan and compressor run only when cooling is needed. Fan stops running when room temperature matches the Temperature control setting. Compressor restarts in 3 minutes after the unit stops. Compressor will not stop running for the first 6 minutes after restarting unless unit is turned off.

NOTE: After 3 seconds, display will show the current room temperature.

Fan Speed

1.Press FAN SPEED until you see the indicator light for the desired setting.

2.Choose Turbo, High, Low or Auto.

•Turbo—for maximum cooling

•High—for normal cooling

•Low—for sleeping comfort

•Auto—automatically controls fan speed depending on current room temperature and temperature control setting

NOTE: Auto fan speed cannot be selected in Fan Only mode.

NOTE: After 3 seconds, display will show the current room temperature.

Filter Reset

1.When FILTER indicator light glows, remove air filter and clean or replace air filter. See “Cleaning the Air Filter.”

2.Replace air filter.

3.Press and hold FILTER after replacing the air filter.

Temperature

•Press the plus TEMP button to raise the temperature. The Set indicator light will turn on. Each time you press or hold the plus TEMP button, the temperature will go up 1º until it reaches 86°F (30°C).

NOTE: After 3 seconds, the Set indicator light will turn off and the display will show the current room temperature.

A

A. Set indicator light

8