NOTE: In order to achieve maximum room cooling efficiency, the exhaust duct should remain as short and straight as possible. To further shorten the exhaust hose, first unthread either exhaust duct adapter clockwise to remove it. Then cut the hose to desired length. It is not recommended to increase the manufacturer’s length of the exhaust hose. This may reduce the cooling efficiency or damage the unit
WINDOW KIT INSTALLATION
a)Open window or sliding door approximately 5 inches (13 cm). Adjust the length of the window kit to the same length of the window or sliding door. Use two or three panels if necessary and secure panels into place by fastening the ¾” Phillips head screws into the
b)Alternatively you may need to mark a single panel and cut it down to properly fit the window opening. The window kit (three panels) has a maximum length 81 inches.
c)Place the window kit between the window and the window frame as shown in the picture to the right. Close the window onto the window kit to form a tight seal.
d)Attach the exhaust duct window kit adapter to the window kit. Tabs located on the adapter will lock into place securing the adapter to the window kit.
NOTE: Using the window kit will cause the window not to be properly closed and locked. Consider taking additional security measurements.
CONTROL PANEL AND LCD SCREEN
9
