a.When the unit is On, press “Timer” Button, then press the “Time” button until the desired number of hours is displayed in the lower right corner of the display window. The unit will automatically power Off once the selected number of hours has elapsed.
b.When the unit is Off, press “Timer” Button, then press the “Time” button until the desired number of hours is displayed in the lower right corner of the display window. The unit will automatically power On once the selected number of hours has elapsed.
NOTE: The timer function must be manually reset before each automatic start or stop.
6.Swing
Activates or deactivates the oscillating louvers
Operation Using the Control Panel
1.Cooling Operation
a.Be sure that the drain bucket is properly placed in the unit. If the drain bucket is not properly secured, the red “Water Full” light located on the front panel will blink and the unit will not begin cooling.
b.Be sure the exhaust duct properly installed. Refer to page 6 for exhaust duct installation.
c.Plug the Power Cord to the power outlet.
d.Turn on the unit by pressing the On/Off Button on the control panel.
e.Press the Mode Button until “COOL” appears on the LCD display.
f.Press the Temperature Button 
or 
until the desired room temperature appears on the LCD. The temperature ranges from
NOTE: During hot days, the unit will cool off the room most efficiently by setting the temperature to the lowest setting and the fan speed to the highest setting (see page 9 for fan operation). Reducing the length of the exhaust duct, insulating the exhaust duct and keeping direct sunlight to a minimum will also improve the cooling efficiency.
2.Dehumidifying Operation
9
