a.Be sure that the drain bucket is properly placed in the unit. If the drain bucket is not properly secured in the unit, the red “Water Full” light located on the front panel will blink and the unit will not begin dehumidifying.
b.If exhaust duct is attached, remove it from the rear of the air conditioner
c.Plug the Power Cord to the power outlet.
d.Turn on the unit by pressing the On/Off Button on the control panel.
e.Press the Mode Button until “DRY” appears on the LCD display.
NOTE: Do not use the exhaust duct when the unit is running at dehumidifying mode. You must remove the exhaust duct from the unit. When the unit is running at dehumidifying mode, the fan speed cannot be adjusted. Keep the windows and the doors closed to aid the efficiency of the unit in removing the moisture from the room.
3.Fan Operation
a.Plug the Power Cord to the power outlet.
b.Turn on the unit by pressing the On/Off Button on the control panel.
c.Press the Mode Button until “COOL” appears on the LCD display.
d.Press the Temperature Button the current room temperature. will appear on the LCD screen.
or 
to set the temperature HIGHER than After two seconds the current room temperature
e.Set the fan speed to “LOW” “MEDIUM” or “HIGH” by pressing the Fan Speed button.
4.Heating Operation
a.Plug the Power Cord to the power outlet.
b.Turn on the unit by pressing the On/Off Button on the control panel.
c.Press the Mode Button until “Heat” appears on the LCD display.
d. Press the Temperature Button
or until the desired room temperature appears on the LCD. The temperature ranges from
NOTE: When the unit is operating in heating mode, the exhaust duct is not required.
10
