a.Plug the Power Cord to the power outlet.
b.Turn on the unit by pressing the On/Off Button on the remote control.
c.Press the Mode Button until “Heat” appears on the LCD display.
d. Press the Temperature Button or until the desired room temperature appears on the LCD. The temperature ranges from
NOTE: When the unit is operating in “HEAT” mode, the exhaust duct is not required.
4.Dehumidifying Operation
a.Be sure that the drain bucket is properly placed in the unit. If the drain bucket is not properly secured, the red “Water Full” light located on the front panel will blink and the unit will not begin dehumidifying.
b.If attached, remove the exhaust duct from the back of the air conditioner
c.Plug the Power Cord to the power outlet.
d.Press the ON/OFF key to turn on the unit
e.Press Mode key until “DRY” appears on the LCD display.
5.Fan Operation
a.Press the ON/OFF key to turn on the unit
b.Press the Mode key unit “COOL” appears on the LCD display.
c. Press either or 
key of the temperature to set the temperature HIGHER than the current room temperature.
d.Press the Fan Speed key until the LCD displays the desired fan speed.
7.Timer
a.When the unit is On, press “Timer” Button, then press the “Hour” button until the
13
