OPERATION
After the water bottle has been connected to the water cooler, the unit is ready for use. Turn the power switch on the back of the unit to ON. The water cooler will start running. First the unit will pump the water from the water bottle into the cooling and heating tanks, and then the unit’s compressor and heater will start to operate. It will take approximately 30 minutes for the water cooler to provide hot and cold water when first plugged in to an outlet.
•Cold Water - To dispense cold water, press the COLD water button on the control panel.
•Hot Water - To dispense hot water, press the HOT water button and the LOCK button on the control panel.
•Reset - Once you have replaced an empty water bottle with a new full water bottle, the water cooler will reset itself and begin pumping water as soon as the door closes.
CLEANING & MAINTENANCE
1.To avoid accidents, turn off and unplug the water cooler from the outlet before cleaning.
2.A soft damp cloth may be used to clean the surface of the water cooler. When necessary, a mild deter- gent may be used. DO NOT use erosive chemical solvents to clean the unit, as this may damage the surface of the water cooler.
3.DO NOT pour water on the exterior of the unit to avoid getting the internal electrical system damp. DO NOT immerse the unit in water when cleaning.
4.The water bottle cap, hose, and drip tray may be washed in a dishwasher (top rack only).
5.Keep the water cooler 6 inches (15cm) away from the wall so it can work properly. Make certain all ventilation openings are clear of obstruction.
6.Do not damage the heating or cooling system, paying particular attention to the black condenser or heat radiator on the back of the water cooler.
7.If you will not use the water cooler for a long period of time, please unplug the power cord and drain the water cooler. Drain the water from all faucets, then remove the drain cap on back and allow it to drain. Make certain the drain cap is fastened tightly when finished.
8
