![](/images/new-backgrounds/1203401/20340155x1.webp)
NOTE: The FLASH EPROM program is
Step 5: The PGM7041.EXE file is a program that loads and writes the ROM pattern files onto the (FLASH) memory chips. To program the FLASH EPROM.
Step 6: In the DOS prompt type the command as follows.
C:\>PGM7041 [ROM pattern file name]
Step 7: In the main menu, choose the <Load ROM File> item, that is the ROM_NAME=[file name] in the *.PGF file.
Step 8: Choose the <Program Memory> item, this item program will program the EPROMs.
NOTE: Move the reverse video bar to the <Program memory> option then press <ENTER>. PGM7041 will write the ROM pattern files onto the (FLASH) memories. Ensure that data is verified by the PGM7041 correctly.
Step 9: Reboot the system
NOTE: Reboot your computer by making a software or hardware reset.
3.4.3 Small Page 5V FLASH ROM Disk
(1) Switch and Jumper Setting
Step 1: Use jumper block to set the memory type as ROM (FLASH).
Step 2: Select the proper I/O base port, firmware address, disk drive number and EPROM type on SW1.
Step 3: Insert programmed EPROM(s) or FLASH(s) chips into sockets starting at MEM1.
ON
OFF 1 2 3 4 5 6 7 8 9 10