JVC SP-MXSK3 7, Connecting Speakers, 1Connect the AM loop antenna to the AM, terminal, AM antenna

Continued

English

AM antenna

Vinyl-covered wire
(not supplied)
	ANTENNA
1	FM 75Ω
	COAXIAL
2
	AM loop antenna
	(supplied)

1Connect the AM loop antenna to the AM

LOOP terminals as illustrated.

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Connecting Speakers

	SPEAKERS	SPEAKERS
	2
1
	3
Red	SPEAKERS
	Red
	CAUTION:
Black	SPEAKER IMPEDANCE
	6 ~ 16 Ω
	Speaker cords
	(red/black)
Right speaker	Left speaker

1Press and hold the clamp of the speaker terminals on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity (colours) of the speaker terminals: Red

(+) to red (+) and black (–) to black (–).

3Release your finger from the clamp to close the speaker terminals.

Speaker Setting For A/V Combination

SP-MXSK3 and SP-MXSK1 have a magnetically-shielded design for placement adjacent to TV’s and monitors without causing color aberrations. However, color may be affected by the way of installing the speaker system. Therefore, please take note of the following:

1.When placing these speakers near a TV set, turn off TV’s main power switch or unplug it before installing the speakers. Wait at least 30 minutes after the system is installed before turning on the TV’s power.

2.If another speaker system has been set up near the TV set, that system may cause color unevenness in the TV’s picture.

3.In spite of the shielded design of these speakers, some of the TV types may be affected by them. If this happens, move the speakers to a short distance away from the TV set.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –