JVC MX-SK3, MX-SK1, CA-MXSK3, SP-MXSK1, SP-MXSK3 You can set the clock whether the unit is on or off

Common Operations

English

Turning On or Off the Power

To turn on the unit, press STANDBY/ON

To adjust the clock again

Make sure the ˚ (timer) indicator is not lit on the display.

• If it is lit, press and hold CLOCK/TIMER until it goes off.

STANDBY/ON so that the

STANDBY lamp goes off.

To turn off the unit (on standby), press again so that the STANDBY lamp lights up.

OR

STANDBY/ON

If you have adjusted the clock before, you need to press

CLOCK/TIMER repeatedly until the clock setting mode is

selected.

• Each time you press the button, the clock/timer setting

modes change as follows:

ON

STANDBY/ON

OR

•A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away, while the tuner preset stations (see page 12) will be erased in a few days.

OFF

DAILY TUNER REC TUNER

DAILY TAPE DAILY CD

Volume setting

Clock setting

OK

When you unplug the AC power cord or if a power failure occurs

The clock loses the setting and is reset to “0:00.” You need to set the clock again. The clock may gain or lose 1 to 2 minutes per month. If this happens, set the clock again.

Setting the Clock	Setting the AM Tuner Interval Spacing
Before operating the unit any further, first set the built in clock.
	Some countries space AM stations 9 kHz apart, and some
You can set the clock whether the unit is on or off.
	countries use 10 kHz spacing.

On the unit ONLY:

1 Press CLOCK/TIMER.

The hour digit start flashing on the display.

2 Press 4 or ¢ to adjust the hour, then press CLOCK/TIMER to set the hour.

SET appear on display.

The minute digits start flashing on the display.

3 Press 4 or ¢ to adjust the minute, then press CLOCK/TIMER to set the minute. SET appear on display.

On the unit ONLY:

You can only change the AM tuner interval spacing while in

STANDBY MODE.

Press STANDBY/ON

while holding down +/33 for 10 kHz or –/22for 9 kHz interval spacing when you change the setting.

The preset stations are erased. You will need to preset the station again.

– 9 –