F.4
F.4.1
F.4.2
F.4.3
F.4.4
F.4.5
Configuration
Dim Level
The attenuation applied to the monitor signal when the ‘DIM’ switch is active is set by the Total Recall processor. The default level is
• Press and hold SETUP/MIDI until the SETUP/MIDI LED flashes.
• Use the
• Use the
• Press the
MIDI Remote Control
Controlling the ‘soft’ controls (see next page for list) on the XR622 Master module via MIDI requires MIDI remote mode to be enabled. Optionally the
Selecting MIDI remote mode
To select MIDI remote mode:
• Press and hold SETUP/MIDI until the SETUP/MIDI LED flashes.
• Use the
• Use the
• Press the
Once MIDI remote mode is selected the unit will behave as normal until a MIDI controller message corresponding to one of the soft controls is received. This will lock out all of the ‘soft’ front panel controls, retaining the current settings until a corresponding controller message is received. The right hand decimal point in the display window lights to show that the unit is in MIDI remote active mode.
Changing the MIDI channel
• Press and hold SETUP/MIDI until the SETUP/MIDI LED flashes.
• Use the
• Use the
• Use the
Changing the MIDI controller assignments
The default controller mapping is shown below:
| ||
Default MIDI Controller Mapping | ||
MIDI Controller |
| Master Module Control |
| ||
1 |
| MIX |
2 |
| REC |
3 |
| EXT |
4 |
| ALT |
5 |
| MONO |
6 |
| DIM |
7 |
| CUT |
8 |
| AFL Level |
9 |
| Monitor LEVEL |