CONNECTING THE EMITTERS
•Simply insert the mono mini plug of the VE1 and VE2 emitters into the "EMITTERS" or "OUT" jacks on any of the Sonance Connecting Blocks or Controllers.
•CAUTION: DO NOT plug emitters into the IN/OUT or HIGH OUT jacks on the CB1 and ACB1 Connecting Blocks. To do so will destroy the emitters!
•The following diagram illustrates a typical basic system using the VE1 and VE2 emitters.
PS1 | Satellite Receiver | |
Power Supply | IR Sensor | |
Window | ||
| ||
120 V AC |
| |
(Unswitched) |
|
CB1
Connecting Block
PWR
|
| +12VDC | EMITTERS CB1 ONEZONE CONNECTING |
| ||||
|
|
|
|
|
|
|
|
|
|
| GND |
|
|
|
| ||
|
| GND |
|
|
|
| ||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
| SIGNAL | BLOCK |
|
|
| ||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
| IR RCVR |
|
|
| |||
|
|
|
|
| ||||
|
|
|
|
|
|
|
| |
VE1 Emitter
DVD
VE2 Dual Emitter
AV Receiver
VE2 Dual Emitter
EQUIPMENT CABINET, CLOSET, ETC.
CR1
IR Receiver
Hand Held
Remote
•The VE2 is designed to control two devices. If only one is to be controlled, hide the extra emitter behind the equipment. It may be used in the future if an extra device is added.
•DO NOT CUT the extra emitter wire in an attempt to remove it. The two emitters are wired in series. Cutting or removing one emitter will prevent the other from working.
•These visible emitters may also indicate the presence of stray IR or RF interference by randomly blinking when no IR control signal is being sent. Reposition the IR receiver or the interfering source to eliminate or reduce the random blinking. The more the random blinking is reduced, the better the system will function.
•If the emitter glows red constantly, the signal line is shorted to “+12VDC” or a constant noise, like florescent lights are present near the IR receiver.
|
|
| Pg |
| 2 |
|
|
|
|
|
| ||
|
|
|
| |||
| SONANCE • 212 Avenida Fabricante • San Clemente, CA 92672 | |||||
Tech Support (800)
