Page 38 Configuring Deployment Settings
Configuring Deployment Settings
This section describes the settings available on the
Deployment > Settings page of the appliance management
interface.

Configuring Web Port Settings

To change the Web port settings, perform the following steps:
1. On the Deployment > Settings page under Web Port
Configuration, to use a different port for HTTP access to
the SonicWALL UMAEM5000, type the port number into
the HTTP Port field. The default port is 80.
2. To use a different port for HTTPS access to the
SonicWALL UMAEM5000, type the port number into the
HTTPS Port field. The default port is 443.
3. Click Update to apply the Web port settings.
Note: Changing the Web port settings will cause the
appliance to restart.
4. After the appliance restarts, use the new port to access the
appliance management interface. For example:
• If you changed the HTTP port to 8080, use the URL:
http://<IP Address>:8080/appliance/
• If you changed the HTTPS port to 4430, use the URL:
http://<IP Address>:4430/appliance/

Configuring SMTP Settings

The SMTP settings are used for sending email alerts to the
SonicWALL UMA EM5000 administrator. To configure the
SMTP settings, perform the following steps:
1. On the Deployment > Settings page under SMTP
Configuration, enter the IP address of the SMTP server
into the SMTP server field.
2. In the Sender address field, enter the email address that
will appear as the ‘From’ address when email alerts are
sent to the administrator.
3. In the Administrator address field, enter a valid email
address for the administrator who will receive email alerts.
4. Click Update to apply the SMTP settings.