There is no sound from one of the front speakers.
•Connect a pair of headphones to the PHONES jack to verify that sound is output from the headphones. If only one channel is output from the headphones, the component may not be connected to the receiver correctly. Check that all the cords are fully inserted into the jacks on both the receiver and the component. If both channels are output from the headphones, the front speaker may not be connected to the receiver correctly. Check the connection of the front speaker which is not outputting any sound.
•Make sure you have connected both the L or R jack to an analog component and not just to either the L or R jack. Use a
There is no sound from analog 2 channel sources.
•Check to make sure the selected audio (digital) input jack is not assigned to other inputs in “Input Assign” in the Input menu (page 103).
There is no sound from digital sources (from COAXIAL or OPTICAL input jack).
•Check that the INPUT MODE is not set to “Analog.”
•Check that the “2ch Analog Direct” is not being used.
•Check to make sure the selected audio (digital) input jack is not assigned to other inputs in “Input Assign” in the Input menu (page 103).
The source sound input from the HDMI IN jack is not output from an amplifier or the TV speaker connected to the receiver.
•Check that the component is connected correctly to the HDMI IN jack for that component.
•Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component.
•Be sure to use a connecting cable for the HDMI jack corresponding to high speed (an HDMI version1.3a, category 2 cable) when you view images or listen to sound during a Deep Color transmission.
The left and right sounds are unbalanced or reversed.
•Check that the speakers and components are connected correctly and securely.
•Adjust the balance parameters using the Auto Calibration settings menu.
There is severe hum or noise.
•Check that the speakers and components are connected securely.
•Check that the connecting cords are away from a transformer or motor, and at least 10 feet (3 meters) away from a TV set or fluorescent light.
•Move your TV away from the audio components.
•Make sure you have grounded the U SIGNAL GND terminal (only when a turntable is connected).
•The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
There is no sound, or only a very low- level sound is heard from the center/ surround/surround back speakers.
•Select a “Cinema Studio EX” mode (page 84).
•Adjust the speaker level (page 115).
166GB