Preparation

In order to mount the S-AIT library, first mount the rails and brackets on the library and rack.

Before beginning work, always be sure to turn off the S- AIT library, and then disconnect all cables.

Pull Out the Inner Rails

Pull out the inner rails from the rail assemblies.1 Pull out the inner rail from one of the rail assemblies as far as it will go.The rail can be extended until the locking arm on the back of the rail emerges.

Back of rail assembly

Locking arm

Inner rail

Rail assembly

2 Turn the rail assembly over. Press the locking arm to release the lock, and then pull the inner rail all of the way out.

3 Repeat the process with the other rail assembly, pulling out its inner rail.

Note

The inner rail will be mounted on the S-AIT library, while the rail assembly will be mounted on the rack.

Preparing the Library

Mount the L-shaped brackets and inner rails on the library.

Caution

Electrostatic charges that build up on your body can damage the components. Before starting work, touch the metal chassis of the S-AIT Library.

Do not touch any components other than those that must be replaced. In the event of damage, a charge will be assessed for repair.

Mounting the L-shaped Brackets

1 Use two A screws to mount an L-shaped bracket on the side of the library as shown in the diagram.

2 Mount the L-shaped bracket on the other side of the library in the same manner.

Mounting the Inner Rails
1 Use four A screws to mount an inner rail on the library.

Inner rail

A screw

Position of screw hole on the left side

2 Mount the other inner rail on the other side of the library in the same fashion.

Preparation 11