Disconnect all of the cables.
Loosen the screws in both of the L-shaped brackets.
Pull the library out of the rack.

3 Press the locking arm to release the lock, and then slide the library all of the way into the rack.

Locking arm

4 Hand tighten the screw on one of the L-shaped brackets on the front of the rack so that the library is secured in place.

Fastener

5 Hand tighten the screw on the other L-shaped bracket the same manner.

6 Confirm that the library is housed properly in the rack.

Once the library is mounted in the rack, connect the power cord and the SCSI cables and make all necessary settings as described in the Quick Start Guide and Operating Instructions (PDF).

Removing the Library from the Rack

Caution

With a single drive installed, the S-AIT library weighs approximately 27 kg/59.5 lbs. (With two drives installed, the S-AIT library weighs approximately 31 kg/68.3 lbs.)

At least two people are needed in order to handle the library. Handling the S-AIT library on your own could result in back injury or other accidents resulting in injury or damage to the S-AIT library.

1 Turn off the library.

To turn the power off, press the rear power switch.

2

3

4

5 If necessary, remove the rail assemblies and brackets from the rack.

6 If necessary, remove the inner rails and L-shaped brackets from the library.

Removing the Library from the Rack

15